Declaration Of Installation Conformity Pursuant To Annex Ii 1 B - Elektror SVD Serie Betriebs- Und Montageanleitung

www.elektror.com

8 DECLARATION OF INSTALLATION CONFORMITY PURSUANT TO ANNEX II 1 B

The manufacturer,
Elektror airsystems gmbh
Hellmuth-Hirth-Strasse 2
D-73760 Ostfi ldern
hereby declares that the product to which this declaration refers meets the basic requirements of the Machinery Directive (2006/42/
EC) as set forth below.
Description of incomplete machine:
Special blowers SVD 8, SVE 8, SVD 10, SVE 10, SVD 12, SVE 12, SVD 14 and SVD 16
The serial number and year of build can be found on the rating plate and on the associated delivery note.
Description of the essential requirements of Machinery Directive (2006/42/EC), with which the partially completed machine
complies:
Machinery Directive (2006/42/EC): Annex I, Articles 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.5.1, 1.6.1, 1.7.1, 1.7.3
Electromagnetic Compatibility Directive (2004/108/EC)
Eco-design Directive for Energy-related Products (2009/125/EC)
The partially completed machine described here continues to fulfi l the protective regulations of the Low Voltage Directive
(2006/95/EC) according to Annex I, No. 1.5.1 of the Machinery Directive.
The commissioning of the partially completed machine is not permitted until it has been verifi ed that the machine in which
the partially completed machine is to be installed, complies with the provisions of the Machinery Directive (2006/42/EC).
The following harmonised standards have been applied:
DIN EN 12100-1 Safety of machinery - Basic concepts, general principles for design
Part 1: Basic terminology, methodology
DIN EN 12100-2 Safety of machinery - Basic concepts, general principles for design,
Part 2: Technical principles and specifi cations
DIN EN 60034-1 Rotating electrical machines, Part 1: Rating and performance
DIN EN 60034-5 Rotating electrical machines, Part 5: Degrees of protection provided by integral design of
rotating electrical machines (IP code) – Introduction
DIN EN 60204-1 Safety of machinery - Electrical equipment of machines,
Part 1: General requirements
DIN EN 60664-1 Insulation co-ordination for equipment within low-voltage systems,
Part 1: Principles, requirements and tests
The manufacturer, Elektror airsystems gmbh, undertakes to make the special documentation on this incomplete machine available,
electronically or in hardcopy, to national authorities on demand. The special technical documentation belonging to this incomplete
machine was prepared in accordance with Annex VII Part B.
Mr Steffen Gagg, tel. +49 (0)711/31973-124, is responsible for the documentation.
Kreher (Managing Director)
Ostfi ldern, 02.05.2013
Operating and assembly instructions SVD
EN
15