Declaration Of Installation Conformity Pursuant To Annex Ii 1 B - Elektror RD-F Montageanleitung Und Bedienungsanleitung

www.elektror.com

8 DECLARATION OF INSTALLATION CONFORMITY PURSUANT TO ANNEX II 1 B

The manufacturer,
Elektror airsystems gmbh
Hellmuth-Hirth-Strasse 2
D-73760 Ostfi ldern
hereby declares that the product to which this declaration refers meets the basic requirements of the Machinery Directive (2006/42/
EC) as set forth below.
Description of incomplete machine:
Conveying blower RD 14 F, RE 14 F, RD 4 F, RE 4 F, RD 5 F, RD 6 F, RD 62 F, RD 64 F,RD 74 F, RD 82 F
Serial number and year of manufacture can be found on the rating plate and on the accompanying delivery slip.
Description of the essential requirements of Machinery Directive (2006/42/EC), with which the partially completed machine
complies:
Machinery Directive (2006/42/EC): Annex I, Articles 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.5.1, 1.6.1, 1.7.1, 1.7.3
Electromagnetic Compatibility Directive (2014/30/EC)
Eco-design Directive for Energy-related Products (2009/125/EC)
The partially completed machine described here continues to fulfi l the protective regulations of the Low Voltage Directive
(2014/35/EC) according to Annex I, No. 1.5.1 of the Machinery Directive.
The commissioning of the partially completed machine is not permitted until it has been verifi ed that the machine in which the
partially completed machine is to be installed, complies with the provisions of the Machinery Directive (2006/42/EC).
The following harmonised standards were applied:
Safety of machinery - General principles of design -
DIN EN 12100 2011
Risk assessment and risk reduction
Rotating electrical machines,
DIN EN 60034-1 2011
Part 1: Rating and performance
Rotating electrical machines,
DIN EN 60034-5 2007
Part 5: Degrees of protection provided by the integral
design of rotating electrical machines (IP code) – Classifi cation
Safety of machinery – Electrical equipment of machines,
DIN EN 60204-1 2007
Part 1: General requirements
Insulation coordination for equipment within low-voltage systems,
DIN EN 60664-1 2008
Part 1: Principles, requirements and tests
The manufacturer, Elektror airsystems gmbh, undertakes to make the special documentation on this incomplete machine available,
electronically or in hardcopy, to national authorities on demand. The special technical documentation belonging to this incomplete
machine was prepared in accordance with Annex VII Part B.
Mr Steffen Gagg, tel. +49(0)711/31973-124, is responsible for the documentation.
Kreher (Managing Director)
Ostfi ldern, 01.06.2015
Operating and assembly instructions RDF
EN
17