Expolite ProPAR X3 COB Bedienungsanleitung Seite 29

Activating Auto Programs
MENU
AUTO PROGRAM
PERSON
In the menu AUTO PROGRAM the automatic programs stored in the device are activated. The
programs AUTO1 to AUTO10 are permanently stored in the device. The programs PROGRAM1 to
PROGRAM10 are editable. This is described under Edit User Programs. Automatic programs are
transmitted as master to connected slave devices. For master-slave operation, signals are sent via
the DMX line. This may disturb other devices on the same line.
Choose Run Mode
MENU
RUN MODE PERSON
The operating mode is set in menu RUN MODE. For operation on a DMX-controller DMX needs to be
set. SLAVE sets the fixture into slave mode.
Edit User Programs
MENU
HSIC EDIT
In the menu EDIT the user programs PROGRAM1 to PROGRAM10 can be edited.
Every program can have up to 10 steps (SCENE-01 - SCENE-10). Every step persists of the
parameter colours RGBALC, STROBE „0-20Hz", TIME and FADE.
User programs can be transfered to other fixtures (see master/slave).
Step-by-step programming of the custom stand-alone programs with up to 10 different steps:
NOTE: For less than 10 steps the TIME and FADE of the last step needs to be set to 0.
Example for time settings of a stand-alone programm with 3 steps:
HSIC AUTO1 SPEED
HSIC AUTO2
o
o
o
HSIC AUTO10
PROGRAM1 HSIC
PROGRAM2 HSIC
o
o
o
PROGRAM10 HSIC
HSIC DMX
HSIC SLAVE
PROGRAM1 SCENE-01
PROGRAM2 SCENE-02
o o
o o
o o
PROGRAM10
SCENE-10
Step 1 TIME = 4 FADE = 3
Step 2 TIME = 5 FADE = 2
Step 3 TIME = 0 FADE = 0
0 - 255
RED 0 - 255
GREEN 0 - 255
BLUE 0 - 255
AMBER 0 - 255
LIME 0 - 255
CYAN 0 - 255
STROBE 0 - 255
TIME 0 - 255
FADE 0 - 255
E-29