Assembly - Maxxus Hyperextension Bedienungs-/Montageanleitung

Assembly

Carefully unpack all delivered parts. Have someone there to help you as some of the training device parts are
bulky and heavy. Check against the parts and fixing material lists above that all the parts and fixing materials
(screws, nuts, etc.) have been delivered before you start with assembly. Assemble the parts carefully as any
damages or defects occurring due to mistakes made at the time of assembly are not covered by the warranty or
guarantee. Therefore, read through the assembly instructions carefully before you start assembling, follow each
assembly step exactly as described and keep to the correct sequence of assembly as instructed. Assembly of
the training device must be carried out thoroughly by an adult person only.
Assemble the training device in a location which is level, clean and clear of obstructions. 2 people are required
to carry out the assembly. Please note that during assembly work and any time you use tools that there is a
possible risk of injury. For this reason, always be careful and thorough in your actions when assembling this
device. Wear suitable work or protective gloves. First only tighten the screws for each assembly step by hand
and then check that they are all positioned correctly. Lock nuts should always only be hand tightened to start
with and then tightened with a wrench. Please note that lock nuts become unusable if they are undone as this
causes damage to the locking function. If lock nuts are loosened, they must be replaced with new ones. Training
can only start once the training device has been fully assembled.
Assembly Step 1:
Push the two end caps (11) onto both ends of the bent base (2). Using two hexagon bolts M10x75 (12), four
washers M10(15) and two lock nuts M10 (17), attach reinforcement plate (7) on the bent base (2) to the front
mount on the main support (1). ENG
Assembly Step 2:
Slide the foam tube (18) through one of the three holes on the main support (1) – your choice will depend on
your body size and can be adjusted at any time to fit. Now slide one of the two round foam rollers (9) onto each
end of the foam tube (18).
15