Troubleshooting Guide - IKEA NUTID Gebrauchsanweisung

ENERGY SAVING TIPS
Attention! if the surface is cracked, turn off the appliance to
prevent the risk of electrical shocks and call the After Sales
Service.
If the Timer function is not used, the cooking zone switches off
automatically after a fixed time that depends on the power level
selected (see table).
Level
1
Time (hour)
6
MAINTENANCE AND CLEANING
Important: never clean the appliance with high pressure water
or steam cleaning equipment.
• Clean the cooktop, when it is cool, after each use. This will
prevent the build-up of dirt and make cleaning easier.
• Use a clean cloth, absorbent kitchen wipes and a mild washing up
liquid or a specific glass ceramic cleaner.
• Remove baked-on dirt with the scraper tool (if supplied) and
specific cleaning products.
• Food spills should be cleaned off before they bake onto the glass-
ceramic surface.
• Do not use abrasive products, corrosive chlorine-based cleaners,
oven-sprays or pan scourers.
• The cooktop should be treated periodically with a proprietary
brand of protective cleaner, following the manufacturer's
instructions.
Important
Periodically check for dust under the appliance, near the cooling
air inlet or the outlet openings. This could hinder the ventilation
and cooling of the electronic module and decrease the
effectiveness of the hob.

TROUBLESHOOTING GUIDE

The glass ceramic induction hob does not work:
• Have you pressed the control buttons following
the instructions in the section "using the hob"?
• Is there perhaps a power failure?
• Did you dry the hob carefully after cleaning it?
1. If one of the following codes is displayed during
use:
E3 - E6
wait a few minutes until the temperature of the
appliance cools down. Than it will work as usual.
2 3 4 5 6
6 4 4 3 3
7 8
2 2
2. If one of the following codes is displayed during
use:
E7 - E8
wait a few seconds than the induction hotplate
will operate as usual.
3. If one of the following codes is displayed when
the hob ON button is pressed:
E1 - E2 - E4 - E5 - Eb - EC
contact the After Sales Service and give them
the code.
Important!
If you are not able to turn the glass ceramic
induction hob off after using it, disconnect it
immediately from the power supply.
21