Storage; Troubleshooting; Technical Data; Disposal - Silvercrest SKV 1200 B2 Bedienungsanleitung

–
Press the blender lid r with the measuring
cup e slightly offset firmly back onto the
blender t . Close the blender lid r by
turning it clockwise as far as the stop back
into the catch on the blender t . Ensure
that the pouring spout on the blender t is
closed .
In most cases, you can achieve sufficiently hygienic
cleaning of the blender t immediately after use in
the following way:
1) Put some water containing a little detergent
into the fully assembled blender t .
2) Press the blender lid r with the measuring cup e
slightly offset firmly onto the blender t .
Close the blender lid r by turning it clockwise
as far as the stop back into the catch on the
blender t . Ensure that the pouring spout on
the blender t is closed .
3) Switch on the blender t for a few seconds .
4) Pour out the washing water . Any residues can
be removed with a washing-up brush .
5) Then rinse out the blender t with plenty of
clean water so that all detergent residues are
removed .

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location .

Troubleshooting

If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut-out .
–
Turn the rotary switch 3 to 0 .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 15 minutes .
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start .
–
Wait a further 15 minutes and try switching
on again .
SKV 1200 B2
If the appliance cannot be switched on:
–
Check that the plug is correctly connected
to a wall socket .
–
Check whether the swivel arm 1 is in the
wcorrect position .

Technical data

Supply voltage:
Power consumption:
CO times:
Max . capacity
Mixing bowl 6:
Blender t:
All parts of this appliance that come into
contact with food are food-safe .
We recommend the following operating times:
When working with the kneading hook 0, whisk q
or beater w, allow the appliance to cool down
after 10 minutes of operation .
When working with the blender t, allow the ap-
pliance to cool down after 3 minutes of operation .
If you exceed these operating times, the appliance
can overheat and be damaged!

Disposal

Never dispose of the appli-
ance in your normal domestic
waste . This product is subject
to the provisions of European
Directive 2012/19/EU .
Dispose of the appliance via an approved disposal
company or your municipal waste facility . Please
comply with all applicable regulations . Please
contact your waste disposal centre if you are in
any doubt .
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling plant .
220 - 240 V ~
50/60 Hz
1200 W
Food processor 10 min .
Blender 3 min .
approx . 6 .0 l
approx . 1 .5 l
GB │ IE 27
│
■