Installation - Klarstein 10032903 Bedienungsanleitung

INSTALLATION

Installation with outside vent
If you have an outlet to the outside, your cooker hood
can be connected as on the picture on the right by means
of an extraction duct (enamel, aluminium, flexible pipe
or inflammable material with an interior diameter of
150 mm).
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10
1 Before installation, turn the unit off and unplug it from the outlet.
2 The cooker hood should be placed at a height of 65-75 cm above the cooking
surface for best efficiency.
3 Install the cooker hood between two cupboards. Drill and screw on the side boards
of the cupboards (the holes should not be larger than 2 mm).The distance between
the head of the screw and the side board should be 5 mm, and the distance
between the screw and the cooking surface should no less than 1040 mm. If there is
not room enough, you can place it higher or lower.
4 Hang the cooker hood on the screws between the two cupboards.
-5
Bar).
EN
21