Spring Balancer; Handling; Switching On; Switching Off - EFA SK16-8D Originalbetriebsanleitung

3.2.3 Spring balancer

The machine must always be operated in
combination with a weight relief system (spring
balancer). Install this with a sliding crane trolley
above the working area on an element
assembled higher or on the ceiling. Information
on fine adjustment of the spring balancer is
provided in Chapter "Einstellung des
Federzuges".
Suspend the rib saw top-heavy, if possible.
The vertical position can be adjusted, if
necessary.
Due to the weight of approx. 3 kg, there is a
risk of injury through the unit slipping or falling
down when fixing or loosening the weight relief
system. Pay attention that the device does not
catch on the snap hooks or hooks in the rib
saw. Work cautiously!
Risk of injury!
When using or adjusting a
spring balancer in combination
with the rib saw!
When the rib saw is not being used, it must be
set down so that there is no risk of
unintentional contact with the sharp saw blade.

4. Handling

Risk of injury!
Never reach in near the saw
blade when in operation.
Otherwise, limbs may be cut or
severed!
Wear eye protection or safety
goggles when completing
work!
Schmid & Wezel

4.1 Switching on

•
Ensure that the rib saw is connected to the
local compressed air supply (supply
pressure of 7 bar).
•
Carry out a function test before starting
work.
•
Hold the unit firmly by the handle (1).
1
Fig. 2: Switch operation
•
Press the switch lever (2) with your index
and middle finger to switch on the unit (see
Fig. 2).
Improper use will result in
increased wear!
Hearing impairment!
Ear protection is
recommended when used in
continuous operation!

4.2 Switching off

•
Remove your index and middle finger from
the switch lever.
The switch is automatically switched off by
means of the return spring.
The saw blade can be switched on and off at
any time.
Seite / Page
33 / 53
2
Ausführung / Version
02 / 2011