Cleaning And Care / Storage; Replacing The Rechargeable Battery; Troubleshooting - LIVARNOLUX IAN 311710 Montage-, Bedienungs- Und Sicherheitshinweise

Push the assembled product far enough into
the ground (grass, flower bed) so it is stable.
Make sure it is firmly placed.
Do not use force during assembly or setup, e.g.
hammer blows. This damages the product.
RISK OF INJURY! Make sure that when the solar
light is removed, the ground stake is also removed,
so that it cannot pose any risk (e.g. stumbling over
it).

Cleaning and care / storage

Never use caustic cleaners.
First switch off the product.
Regularly clean the product with a dry, lint-free
cloth. Use a slightly moist cloth to remove any
stubborn dirt.
Note: Be sure the solar cell
achieve good charging.
Cold temperatures have a negative impact on the
rechargeable battery operating time. When not us-
ing the product for extended periods, e.g. in winter,
it should be cleaned and stored in a dry, warm lo-
cation. Be sure the ON / OFF switch
the „OFF" position during storage.
Replacing the rechargeable
battery (see Fig. D–G)
Remove the lamp shade
off the base . The battery compartment
2
is located inside the lamp shade
Set the ON / OFF switch
position (see Fig. D).
Carefully press the brackets of the battery cover
together. Disconnect the battery cover
7
from the battery compartment
them against each other.
Flip open the battery cover
Remove the old rechargeable battery
is always clean to
5
is set to
6
by lightly pulling it
1
8
.
1
to the „OFF"
6
7
by pushing
8
.
7
.
9
Insert the new rechargeable battery into the
battery compartment
polarity.
Connect the battery cover
compartment by pushing them into each
8
other again.
Fold the battery compartment cover
again, ensuring that it engage.

Troubleshooting

Problem Cause
The light will The product is
not switch on not switched
even though on.
the sun shone
on the product
all day.
Limited battery The recharge-
power. able battery
is drained
9
or the solar
cell
The light does Artificial light
not come on sources, e.g.
or only comes street lights, are
on briefly. interfering with
the product.
The product contains delicate electronic components.
This means that if it is placed near an object that
transmits radio signals, it could cause interference.
If the display indicates a problem, move such ob-
jects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the
rechargeable battery for a short while and then
replace it.
, observing the correct
8
with the battery
7
closed
7
Solution
Press the ON /
OFF switch
into the „ON"
position to
switch on the
product.
Replace the
battery.
is dirty.
5
Place the
product in a
location where
other light
sources will
not interfere
with it.
GB/IE
6
17