Operation; Energy Saving Tips - Dometic RC 10.4 70 Montage- Und Bedienungsanleitung

Operation

➤ To operate the refrigerator with a AC mains supply, use a CoolPower EPS100W
or MPS35 rectifier.
7.5 Mounting the refrigerator
!
CAUTION!
Only drill through the washers provided, otherwise foamed compo-
nents, including cables, can be damaged.
I
NOTE
Attach the side walls or the attached strips so that the screws are tight,
even when under increased loads (while driving).
Proceed as follows (fig. 0, page 9):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws through the four plastic washers in the sides of the refrig-
erator into the wall (1).
➤ Put the caps onto the screw heads.
8 Operation
I
NOTE
Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 26).
8.1

Energy saving tips

•
Choose a well ventilated installation location which is protected from direct
sunlight.
•
Allow food to cool down first before placing it in the device.
•
Do not open the cooling device more often than necessary.
•
Do not leave the door open for longer than necessary.
•
Defrost the cooling device as soon as a layer of ice forms.
•
Avoid unnecessarily low temperatures.
•
Clean the condenser of dust impurities at regular intervals.
22
RC10.4 70, RC10.4 90
EN