Dometic RC 10.4 70 Montage- Und Bedienungsanleitung Seite 21

RC10.4 70, RC10.4 90
Key for fig. 9, page 8
Co-ordinate axis
l
∅
A
NOTICE!
Make sure that the polarity is correct.
•
Before starting the device for the first time, check whether the operating voltage
and the battery voltage correspond (see type plate).
➤ Connect the cooling device
– As directly as possible to the pole of the battery or
– To a plug socket which is fused with at least 15 A (at 12 V) or 7.5 A (at 24 V).
A
NOTICE!
Disconnect the cooling device and other power consuming devices
from the battery before connecting the battery to a quick charging
device.
Overvoltage can damage the electronics of the device.
The cooling device is equipped with an electronic device to protect against
reversing the polarity and short circuits when connecting to a battery. To protect the
battery, the cooling device switches off automatically if the voltage is insufficient
(see table below).
Switch-off voltage
Switch-on voltage
Connecting to AC mains supply
D
DANGER!
•
Never handle plugs and switches with wet hands or if you are
standing in a puddle.
•
If you are operating your cooling device on board a boat with
a mains connection from the land, you must install a ground protec-
tion circuit breaker between the AC mains supply and the cooling
device.
Seek advice from a trained technician.
EN
Setting up and connecting the refrigerator
Meaning
Cable length
Cable cross section
12 V
10.4 V
11.7 V
Unit
m
mm²
24 V
22.8 V
24.2 V
21