Logo - Faema E71 Gebrauch Und Installation

20. Logo

The Faema standard logos are shown on all the machine
displays, after a period of inactivity set for the "Screensaver"
menu by the technician.
Technical staff can activate the parameter that allows to show on the services display or even on the groups display a
further logo customized by the user.
The machine is supplied with the logo shown in the image (EXPRESS YOUR ART).
The user can replace it with another of the same size that will will appear on all displays (groups and
To create a customised logo, proceed as follows:
1
Using any graphics program (e.g. Paint),
the prerequisites for a bitmap image to be
used as a custom logo are:
custlogo.bmp
logosrv.bmp
• width less than • width less than
or equal to 260 or equal to 272
pixels pixels
• length less than • length less than
or equal to 110 or equal to 480
pixels. pixels.
• 2 4 - b i t b m p • 2 4 - b i t
colour. colour.
bmp" and / or "logosrv.bmp" if the user
wants to display a logo for the groups
display and one for the services display.
custlogo.bmp" if the user
wants to display the same logo on all
displays.
NOTE: If in the USB pen drive there are all
custlogo.bmp".
4
custlogo.bmp
logosrv.bmp
2
Insert the USB pen drive in the
dedicated slot on the machine:
logogrp.bmp
b m p
3
will appear on the services display:
logogrp.
If in the USB pen drive there is the
logogrp.bmp and / or logosrv.
bmp
5
Once loading is complete, remove the USB pen drive from the machine.
At this point, the custom logo will be displayed according to the settings
programmed by the technical staff.
Note: If the screensaver is active, it is possible immediately see the logos, without
waiting for idle time, every time the user turns off the analogically gauge.
logogrp.bmp - 272 x
the icon will appear on the
services display:
If in the USB pen drive there is the
custlogo.bmp