Flexim PIOX SM Ergänzung Zur Bedienungsanleitung Seite 29

Supplement to User Manual - ENGLISH
• Stop the measurement.
• Select the program branch Parameter. Press ENTER until FLUID c-Calibr. is displayed.
FLUID c-Calibr.
Edit? no >YES<
c-Calibr.
1 TYPE
c-Calibr. [m/s]
0.0 K0
...
c-Calibr. [m/s]
Save? no >YES<
Concentr.Correc.
0.000 M%
• Repeat the steps if it is necessary to correct K
Offset
An offset is only valid for the operating point and should, therefore, only be entered after the calibration coefficient K
been determined exactly.
Concentr.Correc.
0.000 M%
• Create a start-up protocol (see annex A).
Further optimization
If a further optimization of the measurement is necessary, send the stored measurement data, the start-up protocol, the ref-
erence values and additional information about the process conditions during the measurement to FLEXIM (see annex A).
SUPIOX-SV3-0, 2011-11-29
Select yes. Press ENTER.
Enter 1 for the calibration function. Press ENTER.
Enter K . Press ENTER.
0
Enter 0 for the calibration coefficients K
Select yes to store the calibration coefficients. Press ENTER.
Enter 0. Press ENTER.
.
0
Enter an offset. Press ENTER.
...K . Press ENTER.
1 4
Measurement with PIOX S
has
0
29