Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Measurement with PIOX S
1.6
Parameter Input
>PAR<mea opt sf
Parameter
• Enter the pipe parameters. Press ENTER.
• Enter the medium parameters. Select the user defined medium. Press ENTER.
• Enter the parameters for the concentration measurement (see section 1.6.1).
1.6.1
Parameters of the Concentration Measurement
Comparison of the sound speed of the medium
The measurement can be calibrated with a defined medium. The currently measured sound speed c
theoretical or expected value c
ment.
Compare fluid
↕
Water
Calibration Polynomial
For explanation see section 1.1.1 under Measurement principle.
FLUID c-Calibr.
Edit? no
>YES<
c-Calibr.
1
TYPE
c-Calibr.
[m/s]
0.0 K0
c-Calibr.
[m/s]
Save? no
>YES<
1.6.2
Offset Correction
Deviations of the parameters during the installation from the laboratory parameters can be corrected by a constant value
(offset) added to the calculated concentration.
Concentr.Correc.
0.000
M%
1.7
Storing
• Activate the storing of the measured values.
SYSTEM settings↕
Storing
Store Amplitude
off
>ON<
Store c-Medium
off
>ON<
26
Select the program branch Parameter. Press ENTER.
of the reference medium. The difference Δc = c
M2
Select the reference medium. Press ENTER.
This display will only be indicated if Special Funct.\SYSTEM settings\Measur-
ing\Compare c-fluid is activated.
Select yes. Press ENTER.
Enter 1 for the calibration function. Press ENTER.
Enter 0 for the calibration coefficients K
Select yes to store the calibration coefficients. Press ENTER.
Enter 0. Press ENTER.
Select Special Funct.\SYSTEM settings\ Storing.
Press ENTER until Store Amplitude is displayed. Select on to store the signal ampli-
tude. Press ENTER.
Select on to store the sound speed of the medium. Press ENTER.
Supplement to User Manual - ENGLISH
- c
is displayed during the measure-
m
M2
...K
. Press ENTER after each input.
0
4
is compared to the
m
SUPIOX-SV3-0, 2011-11-29
Werbung
Kapitel
Inhaltsverzeichnis
