Measuring - Testo 735 Bedienungsanleitung

7. Measuring

50
7.
This chapter describes the steps that are required to perform measurements
with the product.
Particular probes must be plugged in or switched on and registered (radio
probes) according to the variable that is to be measured.
Some probes require a warming-up phase until they are ready to measure.
Taking a a m m easurement:
The instrument is in measurement view.
The measuring program AUTO is not activated (735-2 only).
Put the probe in position and take the readings.
Changing t t he u u pper m m easurement c c hannel l l ine d d isplay:
Press
Changing t t he l l ower m m easurement c c hannel l l ine d d isplay, s s howing t t he
max./min. v v alue o o f t t he v v ariable i i n t t he u u pper m m easurement c c hannel l l ine:
Press
- The following are displayed in consecutive order:
Resetting m m ax./min. v v alues:
The minimum or maximum values of all measurement channels are reset.
Press
1
Reset the max./min. values with
2
Holding r r eadings:
Press
Press
Saving r r eadings ( ( 735-2 2 o o nly):
Press
- A measurement protocol with the readings of all available measurement
nfo@Testo-Direct.com
Measuring
.
.
· Available measurement channels
· Maximum value of the variable in the upper display line
· Minimum value of the variable in the upper display line
· Lower measurement line not shown
several times until the maximum or minimum value is displayed.
.
Hold
to change back to displaying the actual reading.
Act
.
Save
channels is created for the active location.
www.
.
Reset
Testo-Direct
1.888.610.766
.com