Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Special Precautions When Dealing
with R410A Unit
50mm or more from walls
(on both sides)
Air-Purifying Filter with
Air-Purifying Filter with
bacteriostatic virustatic
function
Outdoor Unit
The outdoor unit must be installed in such a way, so as to
prevent short circuit of the hot discharged air or obstruction
to the smooth air flow. Please follow the installation
clearances shown in the figure. Select the coolest possible
place where intake air temperature is not greater than the
outside air temperature (maximum 45°C).
Installation clearances
Dimension
300
mm (in)
(11.8)
Note: If there is any obstacle higher than 2m, or if there is
any obstruction at the upper part of the unit, please allow
more space than the figure indicated in the above table.
CONTENTS
page 1
page 3
page 4
page 5
page 5-6
page 6
page 8
page 9
page 10
INSTALLATION DIAGRAM
30mm or more from ceiling
M4 x 12L
Opening service lid
Service lid is opening/closing
type.
Opening method
1) Remove the service lid
screws.
2) Pull out the service lid
diagonally down in the
direction of the arrow.
3) Pull down.
Air filter
INSTALLATION OF THE OUTDOOR UNIT
C
D
300
500
(39.4)
(11.8)
(19.7)
- Vacuuming And Charging
- Indicator Lights
- Air Conditioner Unit Operation
- Operating Range
- Air Filter
- Auto Random Re-Start Function
- Service And Maintenance
- Troubleshooting
Caulk pipe
hole gap
with putty.
Service lid
A
C
1-5
page 10
page 11
page 13
page 13
page 14
page 15
page 15
page 16
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
B
D
Werbung
Kapitel
Inhaltsverzeichnis
