Advantech DLT-V83 series Sicherheitshinweise Und Installationsanleitung Seite 31

8 ATTACHING THE CABLE COVER
To prevent fluids or dust penetrating the DLT-V83 during ongoing operation, the cable
compartment on the device must be sealed using the corresponding cable cover. The
protection class is only ensured if the cable cover is properly installed.
8.1 Attaching the cable cover without integrated UPS battery
− Place the cable cover in the DLT-V83 housing slot.
− Tighten the thin shaft screws (self-retaining) loosely.
− Then fully tighten the screws alternately (crosswise) to a torque of 3 Nm.
8.2 OR: Attaching the cable cover with integrated UPS battery
WARNING
Cable cover contains battery pack. Before connecting and disconnecting the cable
cover, the DLT-V83 must be de-energized.
− Hold the cable cover against the bottom edge of
the DLT-V83, as shown in the picture.
The connecting cables of the UPS must point in the
direction of the connector panel.
− Insert the connector, with the latch aligned correctly, into
the connector panel socket marked UPS optional .
− Place the cable cover into the housing groove of
the DLT-V83.
− Make sure that the battery cable is not jammed.
− Tighten the thin shaft screws (self-retaining) loosely in
the holes of the cable cover.
− Then fully tighten the screws crosswise to a torque
of 3 Nm.
27