Advantech DLT-V83 series Sicherheitshinweise Und Installationsanleitung Seite 29

Please note:
From STEP 2 the information applies to all devices, AC and DC!
STEP 2: Fit cable grommet onto power supply cable (AC or DC variant) and
secure to the strain relief
− Fit a suitable cable grommet onto the power supply cable.
NOTICE: The cable grommet must completely surround the cable.
The opening of the cable grommet must be slightly smaller than the
cable diameter.
If the opening is too large or too small, the sealing of the device will not
be ensured.
− Place the power supply cable, plus cable grommet, into the strain relief
rail cable passage.
− Place one cable clip on the power supply cable.
− Secure the cable clip to the strain relief rail using 2 mounting screws
(M3x5L).
− Tighten the mounting screw with alternating force.
NOTICE:
− Tighten the mounting screws sufficiently but make sure not to pinch
the cable. Otherwise, the cables may break or the insulation may be
damaged.
− Make sure that the power supply cables are run without kinks and are
mechanically protected (securely protected against crushing and
abrading).
The graphic shows the mounting system for all cables to be connected:
− Appropriate cable grommet on the cable
− Insert into the cable passage
− Secure using cable clip and screws to the
strain relief rail
25