Maintenance And Care; Contact Information - Eufab 16458 Bedienungsanleitung

Mounting to the air vent
Fit the clamps of the holder to a fin of the air vent.
Mounting to the windscreen
Fold the lever on the base of the holder upwards in the direction of the holding
arm. Place the inductive charger with the suction base on the windscreen and
push firmly against the glass, and then fold the lever downwards, Figure 1.
To release the holder, fold the lever on the base of the inductive charger up to-
wards the holding arm. Pull the tab on the suction base seal upwards to release
the base from the windscreen, Figure 2.
Connecting the inductive charger
Plug the micro-USB-B connector of the charging cable into the charging socket of
the inductive charger, Figure 3. Connect the USB connector of the charging cable
to a USB port of your vehicle or with a USB vehicle charger. The inductive charger
is now ready for use.
Charging
Pull the holder for the smartphone apart and hold firmly. Position the smartphone in between and then
release the holder. The charging process is started automatically.
Separate the inductive charger from the on-board network of your vehicle when the
vehicle is switched off, otherwise the battery may be drained.

7. MAINTENANCE AND CARE

When used as directed, the inductive charger is maintenance-free.
Clean the inductive charger with a soft, dry cloth only. Do not use cleaning agents.
The sealing surface of the suction cup may be cleaned with water of a diluted soap solution.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with the household waste! Electrical and electronic
scrap must be collected separately and disposed of in an environmentally responsible
manner for recycling. Please contact your community or city administration regarding
disposal options for electrical and electronic scrap.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 1: Securing the
suction base
Figure 2: Releasing the
suction base
Figure 3: Charging port
info@eal-vertrieb.com
www.eal-vertrieb.com
7