Troubleshooting; Conditions Of Warranty - Qlima D 630 P Gebrauchsanweisung

STORAGE
If the machine will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the container. Allow the container and
the dehumidifier to dry completely.
2. Clean the air filter.
3. Store the device in a dust-free location, preferably covered with a sheet of plastic.
TROUBLE SHOOTING
Check the following before contacting technical support:
Failure
The machine doesn't
work.
Dehumidification func-
tion can not start.
Without wind
It's noisy at work?
E1 Code

CONDITIONS OF WARRANTY

There is a two-year warranty on your dehumidifier from the date of purchase. All material
or manufacturing defects will be repaired free of charge.
The following applies:
Potential causes of failure
Is the power line properly con-
nected??
Is the full water indicator light?
(water tank full or not put in
place)
Is the room temperature is above
35 degrees or under 5 degrees?
Is the filter blocked?
Is the air inlet or outlet blocked?
Is the filter plugged?
Is the machine tilted?
Is the filter blocked?
Coil sensor short circuit or open
circuit
Solution
Connect the plug and socket
well.
Drain the water in the tank and
put it in place.
The protection device is started
and the machine cannot work.
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
Remove the obstruction from the
air inlet or outlet.
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
Move the machine to a flat,
strong position.
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
Check whether the line is loose
or replace the coil sensor.
4
57