BEHA Unitest TELARIS ISO Bedienungsanleitung Seite 25

Switch
LOW-Ω
General
Message
blinking
blinking
Display Indications
Cause
• External voltage has been applied/present.
Immediately disconnect instrument from
circuit.
• Test lead connected to wrong socket.
• Resistance measured higher than
19.99 Ω.
• Resistance of test lead correctly compensated
• Resistance of test lead higher than 1,99Ω
• Test leads defect
• Proceed with battery replacement.
• Discharged batteries.
• TELARIS ISO is active
• TELARIS ISO is ready for measurement
• All Segments are on (display test)
25