Maintenance - Protool Rgp 150-15 E Bedienungsanleitung

RGP 150-15 - GB Seite 14 Freitag, 19. September 2003 11:56 11
Storage
The unit should be stored in a dry place where it is pro-
tected against freezing.
Environmental Protection
Do not open worn out machines and return to the col-
lection facilities provided for recycling.

Maintenance

Periodically clean the ventilation slots (6) on the
motor housing.
After an operating period of approx. 200 hours, the
following maintenance work must be performed:
Renew the grease filling of the gearbox.
When the carbon brushes are worn out, the machine
switches itself off. The machine must then be sent to
customer service for maintenance (see enclosed
sheet).
To verify that the double insulation is intact, the
machine must be subjected to a safety test after-
wards. Therefore, these maintenance tasks are
to be performed only by a professional electro-
workshop.
Guarantee
Our equipment is under warranty for at least 12 months
with regard to material or production faults in accord-
ance with national legislation. In the EU countries, the
warranty period for exclusively private use is 24
months (an invoice or delivery note is required as proof
of purchase).
Damage resulting from, in particular, normal wear and
tear, overloading, improper handling, or caused by the
user or other damage caused by not following the ope-
rating instructions, or any fault acknowledged at the
time of purchase, is not covered by the warranty.
Complaints will only be acknowledged if the equip-
ment has not been dismantled before being sent back to
the suppliers or to an authorised PROTOOL customer
support workshop. Store the operating instructions,
safety notes, spare parts list and proof of purchase in a
safe place. In addition, the manufacturer's current war-
ranty conditions apply.
Note
We reserve the right to make changes to the technical
data contained in this information as a result of ongo-
ing research and development work.
14
Service
See enclosed sheet.
Noise/vibration information
Measured values determined according to EN 50 144.
Typically the A-weighted sound pressure level of the
product is 86 dB (A). The noise level when working
can exceed 99 dB (A). Wear hearing protection!
The typical weighted acceleration is 5.8 m/s
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 50 144-2-3,
EN 55 014-1,EN 55 014 -2, EN 61 000-3-2,
EN 61 000-3-3 according to the provision of the regu-
lations 73/23/EEC, 89/336/EEC, 98/37/EC.
Manfred Kirchner
NAREX âeská Lípa a.s.
Chelãického 1932
470 37 âeská Lípa
Subject to change
2
.