Protool RGP 150-15 E Bedienungsanleitung Seite 12

RGP 150-15 - GB Seite 12 Freitag, 19. September 2003 11:56 11
Choice of Grinding Head
Depending on the application and the application range, various grinding heads are available. For optimal working
results, use the best matching grinding head.
The data for speed preselection contained in the application table are recommendations and should be determined
by practical testing.
Grinding Head Equipped with
"Flat-shaped"
grinding head
with 28 TC
grinding wheels
FZ-RGP 150
"Point-shaped"
grinding head
with 35 TC
grinding wheels
SZ-RGP 150
"Pyramid-
shaped" grind-
ing head with 21
TC grinding
wheels
PZ-RGP 150
Diamond grind-
ing head, 12-
segment grind-
ing disc, coated
with diamond
splinters
DIA-RGP 150
TC grinding
head, grinding
disc coated with
TC splinters
HW-RGP 150
12
Application
Removal of soft plaster surfaces (mineral plaster)
Removal of elastic protection coatings on walls and
floors
Removal of foam crests and adhesive remainders (car-
peting), bottom side remains smooth
Removal of tile adhesive (flow concrete) remainders
Removal of asphalt and protective coatings for concrete
Removal of latex paint or oil paint on gypsum surfaces
Removal of hard plaster surfaces (cement facing)
Removal of irregularities and formwork changeovers
on fresh concrete
Foam crests and adhesive remainders (carpeting),
bottom side is roughened
Removal of tile adhesive (flow concrete) remainders
Removal of resin plaster on heat insulation
Removal of very hard material, e.g., cured epoxy resin
coatings; bottom side is heavily roughened
Grinding of irregularities and projections on plaster
flooring
Roughing and cleaning of aged concrete parts
Smoothing out irregularities on aged concrete
Removal of elastic protection coatings on walls and
floors
Removal of gypsum and aerated concrete
Removal of impurities and contamination on concrete
surfaces
Removal of latex paint or oil paint on gypsum surfaces
Dial
Control
4 - 6
4 - 6
6
3 - 4
1 - 2