Open-Source-Software; Replacing The Filter; Replacing The Side Brushes - Philips FC8778 Bedienungsanleitung

English
18
Open source software
Replacement
Ordering accessories

Replacing the filter

Replacing the side brushes

Your robot runs on open source software. Philips offers to make available
upon request a complete machine-readable copy of the source code on a
medium customarily used for software exchange at a charge not higher than
the cost of physically transferring a copy.
This offer is valid for a period of 3 years after the date of purchase of this
product. To obtain a copy of the source code, please write to:
Open Source Team, Philips Intellectual Property and Standards
P.O. Box 220, 5600 AE Eindhoven, Netherlands
Email address: open.source@philips.com
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).
Replace the filter if it is very dirty or damaged. You can order a new filter
under order number FC8012. See 'Emptying and cleaning the dust container'
in chapter 'Cleaning and maintenance' for instructions on how to remove the
filter from the dust container and how to place it in the dust container.
Replace the side brushes after some time to ensure proper cleaning results.
Note: Always replace the side brushes when you notice signs of wear or
damage. We also recommend that you replace both side brushes at the
same time. You can order spare side brushes as a set under order number
FC8013.
1 To replace the side brushes, grab the old side brushes by the bristles and
pull them off their shafts.