Ordering Accessories; Open-Source-Software - Philips SmartPro Active FC8932 Bedienungsanleitung

2
1

Ordering accessories

Open source software
3 Carefully lift the lid off the dust container and take out the filter.
4 Shake the dust container over a dustbin to empty it. Clean the filter and
the inside of the dust container with a cloth or a toothbrush with soft
bristles. Also clean the suction opening in the bottom of the dust
container.
Caution: Do not clean the dust container and the filter with water or in
the dishwasher.
5 Put the filter back into the dust container. Then place the lid on the dust
container.
6 Put the dust container back into the dust container compartment (1), fold
down the handle (2), and put the top cover back on the robot.
Caution: Always make sure the filter is present inside the dust
container. If you use the robot without the filter inside the dust
container, the fan will be damaged.
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).
Your robot runs on open source software. Philips offers to make available
upon request a complete machine-readable copy of the source code on a
English
21