Transport, Packaging And Storage; Transport Inspection; Storage - Kröber O2 Gebrauchsanweisung

6 Transport, packaging and storage

The following should be noted when transporting the Kröber O2:
–
The unit should only be shipped and transported in its original packaging.
–
For transport, e.g. by car, the unit may stand upright or lay on one of the two
large flat sides.
–
Open the transport box from the top. Do not stand the transport carton upside
down or on one of its narrow sides.

6.1 Transport inspection

It is highly recommended to check the complete delivery for completeness and possible
transport damage, immediately after receipt.
In case of externally detectable transport damage you should not accept the delivery, or only
with reservation. Acknowledge the receipt only with reservation (e.g. on the freight
document). Specify the expected damage and inform the manufacturer immediately.
Hidden damage should be claimed immediately after detection, because damage claims can
only be lodged within the applicable claims periods.
The packaging material should be saved; it may be needed if the unit has to be returned.

6.2 Storage

If the package is to be stored before it is taken into service, please observe the following
instructions:
–
Store in a dry environment. Relative humidity: max. 93 % without condensation.
–
It must be assured that the package is not stored outdoors.
It must also be assured that the floor used for storage is dry over the entire storage
period.
–
Storage temperature -25 to +70°C.
–
Store in a dust-free environment.
–
Avoid mechanical shocks and damages.
Transport, packaging and storage
Kröber O2
67