Batching; Displaying Graphs; Bar Graph - Elcometer 456 Bedienungsanleitung

11 BATCHING (MODEL S & T)
1 To use the Batching memory facility, press the Batch softkey.
2 Select "New Batch" or "Open Existing Batch" to add readings.
3 Copy and review batch data.
4 Select "Edit Batch" to rename, clear readings from or delete a
batch.
5 Fixed Batch Size allows users to pre-define the number of
readings to be stored in a batch. Once all readings have been
taken the gauge automatically opens a new batch with a link
to the original batch name. For Example NewBatch_1 becomes
NewBatch_2, NewBatch_3, etc.

Save each reading into memory or store the average of a pre-defined number of
readings using the Counted Average function.

12 DISPLAYING GRAPHS

12.1 BAR GRAPH

The Bar Graph displays an analogue
representation of the thickness value
together with the highest, lowest and
average reading as measurements are
taken. To display the Bar Graph:
1 Press the Display softkey and select
"Readings & Bar Graph".

If a reading is outside set limits, the white bar and the reading value turn red.

When in "Scan" Mode (Model T), the bar graph is automatically displayed during
each scan.
12.2 RUN CHART (MODEL S & T)
To display the Run Chart of the last 20
readings:
1 Press the Batch softkey.
2 Select "New Batch" or "Open
Existing Batch".
3 Press the Display softkey and select
"Readings & Run Chart".

Red points signify a reading outside the batch's limits (if set).
www.elcometer.com
R
en-8