Ts27R Probe System - Renishaw TS27R Installations- Und Benutzerhandbuch

Alternative interface units
Cable
CNC
machine
MI 8-4 interface
control
MI 8 interface
The TS27R probe is used for tool setting on
CNC machining centres.
For tool length measurements and broken tool
detection, the tool is driven against the probe
stylus in the Z axis. Rotating tools can be set
in X and Y for tool radius offsets.
Screw adjusters allow the stylus to be aligned
with the machine's axes.
An interface unit processes signals between
the probe and the CNC control.

TS27R PROBE SYSTEM

TS27R probe
10
7
9
8
1. Stylus
2. Stylus holder for disc or square styli
3. Captive link
4. Break stem
5. Front cover
6. Probe base holding screws
7. Stylus level alignment – adjusting screws
8. Square stylus axes alignment – adjusting screws
9. Square stylus axes alignment – locking screws
10. Conduit adaptor
Z
7
5
X/Y
4
6
Machine table
1-1
Diameter setting
Rotate tool in
reverse direction
1
2
3
T slot