Operating The On-Screen Display At The Console; Showing The On-Screen Display At The Console - G&D DP1.2-Vision-CAT Installation Und Bedienung

Configuration
Function
Changing the colour of the information display
Information display
Adjusting the transparency of the on-screen display
Automatic closing of the OSD after inactivity
Changing the position of the information dispaly
Changing the position of the on-screen display
The basic operation of the on-screen display (see page 23) and the web application
Config Panel (see page 26) is described on the following pages.

Operating the on-screen display at the console

The on-screen display (OSD) – just like the web application
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module. You can view and edit the settings of the KVM extender only in the remote
OSD of the computer module.
NOTE:
Use the remote hotkey
ure the remote OSD of the computer module and the
to open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see Starting process on page 15).

Showing the on-screen display at the console

How to open the on-screen display:
1. Press
Ctrl+Num
23 · G&D DP1.2-Vision-CAT
(default:
(standard) to open the on-screen display.
Default setting
light green
temporary
average transparency
disabled
left upper corner
centred
Ctrl + Num ) at the console to open and config-
local hotkey
Page
48
49
50
51
52
52
Config Panel , which is
(default: Alt + Num )