Husqvarna 543RBK Bedienungsanweisung Seite 16

1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
mixture.
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
tank of the product.
5. Empty and clean the fuel tank if you do not use the
product for some time.
Note: Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and fuel source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
To start the engine
WARNING: Keep the safety distance of 15
m when the engine starts. There is a risk
that the cutting attachment starts to rotate.
1. Set the stop switch to the start position.
16
2. Push the air purge bulb until the bulb starts to fill with
fuel.
3. Set the choke control in the choke position.
4. Hold the body of the product on the ground with your
left hand. Do not step on the product.
5. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING: Do not wind the starter rope
around your hand.
6. Continue to pull the starter rope handle until the
engine starts.
CAUTION: Do not pull the starter rope
until it stops. Do not let go of the starter
rope when it is fully extended. Release
the starter rope slowly. Risk of damage
to the product.
7. When the engine starts, put the choke control in the
run position and apply full throttle. The throttle trigger
automatically disengages from the start position.
8. Make sure that the engine runs smoothly.
WARNING: Keep body parts away from the
spark plug cap. Risk of burn injuries. Do not
use the product with a damaged spark plug
cap. Risk of electrical shock.
1099 - 001 - 01.03.2019