First Use; Appliance Installation; Mains Plug - SOLIS VAC PREMIUM 574 Bedienungsanleitung

30. The appliance and the sealing bar are itted with overheating protection. To
prevent overheating of the sealing bar, no more than 30 bags in a row may be
sealed using the function Seal.
31. Before using, always check that your hands are clean and dry.
32. Please prevent liquids from being sucked into the vacuum chamber. Should any
liquid be sucked in, it will mostly be collected by the drip tray. In such a case,
empty the drip tray and wipe away all liquid remaining in the vacuum chamber.
33. Use exclusively Solis vacuum bags or containers that were designed for this
appliance. The Solis container must be undamaged and free of cracks. Only
use the appliance for vacuuming and sealing, never use for any other purpose.
34. Unwind the power cord fully before plugging the plug into the socket.
35. Oils or lubricants must not be used with this appliance.
FIRS T US E
s
CAUTION: Before using the appliance always make sure that the appliance
and the containers are absolutely clean and free of damage so that food
does not get contaminated.

APPLIANCE INSTALLATION

Place the appliance on a suitably large, horizontal, clean and dry work surface. Note
that you also need space for the food illed bags to be vacuumed.

MAINS PLUG

Insert the plug into a suitable power socket. The Dry indicator light illuminates.
NOTE: Should you use ready made vacuum bags, you can proceed directly to
point II. of these instructions.
98
I. S EAL IN G A B AG F R OM
V A CU U M FI LM
1. Cut a suitable bag length from the ilm.
(see Fig. 1)
2. Open the appliance cover by pulling up the left
≠
and right release button in the case the appliance
cover is locked shut.
3. Place the open bag end on the sealing bar
open appliance. The bag end should not extend into
the vacuum chamber ¥ .
(see Fig. 2)
4. Close the cover and push down on the two front
corners of the appliance cover until you hear a
„Click" from both sides. The cover is now locked
on both sides.
(see Fig. 3)
CAUTION: Never press the release buttons to close
the cover. Their only purpose is opening the cover.
5. Press the Seal (D) button in order to seal the end
of the bag. The green indicator light lashes several
times and goes out again when the sealing process
is inished.
(see Fig. 4)
6. Once the green indicator light goes out, pull up both
release buttons to open the cover.
(see Fig. 5)
7. Remove the bag with the sealed end.
8. Check if the seal seam is straight and without
creases. Should this not be the case, cut the seal
seam off and repeat the process.
Fig. 1
µ of the
Fig. 2
Fig. 3
Fig. 4
Fig. 5
99