First Use; Appliance Installation; Connecting The Power Plug - SOLIS VAC SMART 577 Bedienungsanleitung

A PPLIAN CE D ES C R IP T I O N
s
A
The control panel with function buttons
For your control, the control light by the function buttons (except the Cancel
button) lights up and / or flashes depending on the function you have activated by
pressing the corresponding button. Once a function has been completed, the cor-
responding control light stops flashing. The blue control light by the Vacuum & Seal
button constantly lights up once the appliance has been connected to the power to
indicate that the appliance is in standby mode.
A Vacuum & Seal
Button with blue control light. Starts evacuation process and automatically seals
afterwards. During the extraction process, the blue control light flashes. Once
the sealing process starts, the green light by Seal flashes additionally. When both
processes are completed, only the blue control light by Vacuum & Seal lights up
constantly. The green light by Seal goes out.
B Cancel
Press this button during use will immediately stop the current vacuuming resp.
sealing process.
C Seal
Button with 2 functions with green indicator light:
1. For manually sealing film bags, f.e. when you wish to make a bag from a roll
and therefore need to seal one end of the bag.
2. For stopping the vacuuming process and immediately sealing the bag in Vacuum
& Seal function. Example: If you have selected the Vacuum & Seal function and
notice the pressure getting too high for the foods in the bag during automatic
vacuuming, you can immediately stop the extraction pump and start the sealing
process by pressing the Seal button.
The green control light flashes while the appliance seals. Once the process
is completed, the green control light goes out, only the blue control light by
Vacuum & Seal lights up constantly.
98
B C
FI RST U SE
s
CAUTION: Before using the appliance always make sure that the appliance
and the containers / bags are absolutely clean and free of damage so that
food does not get contaminated.

APPLIANCE INSTALLATION

Place the appliance on a suitably large, horizontal, clean and dry work surface. Note
that you also need space for the food filled bags to be vacuumed.

CONNECTING THE POWER PLUG

Plug the power plug into a suitable power outlet. The blue control light by Vacuum
& Seal lights up and indicates that the appliance is switched on.
NOTE: Should you use ready made vacuum bags, you can proceed directly to
point II. of these instructions.
99