Trouble Shooting; Fault Correction - Parkside PNTS 1300 D3 Originalbetriebsanleitung

Trouble shooting

Problem
Device does not start
Low or lack of suction
Float does not switch
the appliance off
Dust or dirt is blow
out of the device
Possible cause
Mains voltage is not present
Defective on/off switch
( 3)
Worn carbon brushes
Defective motor
13/14) or
Hose system (
jets ( 18/20) blocked
Suction pipe ( 12) assem-
bled incorrectly
Container ( 6) open
Container ( 6) full
Filter ( 15/16/17) full or
clogged
incorrectly positioned (e.g.
due to jerky movements)
( 21) faulty
( 21) does not move
( 21) faulty
Filter ( 15/16/17) is not
or not correctly assembled

Fault correction

Check plug socket, cable, line,
plug and fuse, where appropri-
ate, repair through electrical
specialist
Repair through customer service
Remove obstructions and block-
ages
Assemble suction pipe correctly
Close container
Empty container
21)
Switch off the equipment so the
ball drops then switch on again
Repair by Customer Care
Repair by Customer Care
G B I E
2 5