Troubleshooting - AXTON A2100X Einbauanleitung

g

TrOUBlESHOOTing

Problem
No music signal on loudspeakers
and STATUS-LED on amp is red or off
A high-pitched buzzing sound
in- or decreasing with engine speed
Crackling sound in- or decreasing
with engine speed
Humming
imPOrTAnT! The amplifier's protection circuitry will shut-off the amplifier in case of short-circuit, overload or DC offset at the
speaker out-puts or in case of overheat (lED red). in case the cause for protection shut-off has been eliminated, the amplifier
will operate normally again (lED green). Otherwise the amplifier will switch into "Protect" again!
28
Cause
● + 12 V and/or (GND/0V) and/or "Remote" line not (properly) connected
● Fuse on amplifier blown
● Main Fuse on car battery side blown
● Short-circuit on any of the speaker outputs
● DC voltage at speaker outputs
● Amplifier overload
● Amplifier overheated
● Bad ground (GND) conntact of amplifier or head unit
● Insufficiently shielded RCA interconnects and/or bad RCA cable routing
(inductive interference of on-board electronics)
● Insufficient interference elimination of ignition circuitry
● Sign of ground loop(s), i.e. multiple ground connections of the car audio
installation or parts thereof.
● Check also ground connections of all other audio components conncected