AXTON A2100X Einbauanleitung Seite 23

5
make sure you are using a main fuse protection for the
+12V power input of the amplifier within max. 20–30 cm
of the car battery and power cables with an amperage,
adequate cross-section and main fuse (for details see section
E: "Connecting").
6
The grOUnD/gnD cable (0 V) should have the same cross-
section as the +12V power cable. Make sure to get a good
chassis ground contact, because poor ground contacts are the
cause for most power problems with car audio installations.
7
Make sure no power, signal or speaker lines are shorting
to chassis ground by using rubber grommets wherever a
cable has to pass through any metal part of the vehicle.
important: Before any wiring, always remove the battery´s
negative terminal to prevent short-circuiting.
23 23