Sources Of Danger; Workplace; Approved Servicing Personnel; Procedure In Case Of Emergency - Columbus SW 2000plus Original Bedienungsanleitung

1.6 Sources of Danger

Drive carefully over thresholds and benches, otherwise damage can come up to
wheels or nozzles, resp.
The device is to be protected against frost, wetness, and long lasting
unchecked insolation.

1.7 Workplace

The workplace is located on the grip of the suction hose.

1.8 Approved Servicing Personnel

This columbus aspirator must be serviced and maintained by qualified and authorised
personnel only.

1.9 Procedure in Case of Emergency

Pull out the mains plug.

2 Description

This columbus dust and water aspirator is employed with its standard accessories for wet
sucking in the internal area of buildings. For further cases of application, particularly dry
sucking (vacuum cleaning), there are further extensive columbus accessories.
It is not suitable for wet sucking of inflammable fluids, vacuum cleaning (dry sucking) and
cleaning of objects to witch dust or fluids jeopardising to health are adhering. A use out of
doors is allowed only if the device is protected against influences of weather.

3 Delivery

To garant a safe transportation, the aspirator will be delivered in pre-assembled state.
Please check the completeness of the consignment.
Tank with cowl
Elastic suction hose
1 suction tube
Tube aspiration nozzle
Rubber-strip set

4 Putting into Service

4.1 Connecting Suction Hose

One end of the suction hose is inserted into the connection tube of the aspiration tank, the
other end is plugged onto the suction tube (tighten both by a slight turn).

4.2 Connecting Tube Aspiration Nozzle

The tube aspiration nozzle is plugged onto the moved-in cone of the suction tube.

4.3 Retooling for Dry Sucking (Vacuum Cleaning)

Equip tube aspiration nozzle with brush strips (special accessories).
Insert textile filter (special accessories). For this switch off the device, release the two tension
arms on the tank and remove the cowl. Insert textile filter with its outside ring into the related
ring groove of the tank exactly.
The textile filter must be inserted into the tank in a way that the hems protruding
over the seams are not visible.
Then plug on cowl and clamp it by the both tension arms.
9