Mitsubishi Electric PAC-IF021B-E Bedienungshandbuch Seite 15

. Remote controller operation
Function Selection of remote
controller
Standard Control Screens
OFF
TIME SUN
˚C
TEMP.
2
1
3
2
TIME SUN
˚C
TEMP.
Set Day/Time
TIME SUN
˚F˚C
˚C
ON
1
Day of the Week
& Time display
˚C
9
ON/OFF
4
Day of the Week Setting
Time Setting
4
˚C
ON/OFF
1
1
<Screen configuration>
For details on setting the language for the remote controller display, refer
to 6.6. Function Selection.
The initial language setting is English.
● Function Selection of remote controller:
Set the functions and ranges available to the remote
controller (timer functions, operating restrictions, etc.)
● Set Day/Time:
Set the current day of the week or time.
● Standard Control Screens:
View and set the air conditioning system's operating
status
<How to change the screen>
A : Hold down both the Mode button 2 and the Timer On/Off button 9
for 2 seconds.
B : Press either of the Set Time buttons (
c : Press the Mode button 2.
.3 Setting the day of the week and time
1. Press the or Set Time button 1 to show display 2.
2. Press the Timer On/Off (Set Day) button 9 to set the day.
* Each press advances the day shown at 3 :
Sun → Mon → ... → Fri → Sat.
3. Press the appropriate Set Time button 1 as necessary to set the time.
* As you hold the button down, the time (at 4) will increment first in
one-minute intervals, then in ten-minute intervals, and then in 1-hour
intervals.
4. After making the appropriate settings at Steps 2 and 3, press the
button 4 to lock in the values.
Note:
The day and time will not appear if clock use has been disabled at
Function Selection of remote controller.
.4 Operation
Available items are different depending on your system.
(Refer to section 3.)
.4.1 Switching
<To Start Operation>
■ Press the ON/OFF button 1.
• The ON lamp 1 and the display area come on.
Note:
When the unit restarts, the previous settings are recalled as fol-
lows.
Remote controller setting
Mode Last operation mode
Temperature setting Last set temperature
<To Stop Operation>
■ Press the ON/OFF button 1 again.
• The ON lamp 1 and the display area goes dark.
Note:
Even if you press the ON/OFF button to restart the system while
turning down the operation, the outdoor unit will not start for about
3 minutes.
This is to prevent the internal components from being damaged.
or ) 1.
15