Parts Name; Operation Section - Mitsubishi Electric PAC-IF021B-E Bedienungshandbuch

. Remote controller operation

.2 Parts name

■ Wired Remote-Controller
Display Section
For purposes of this explanation,
all parts of the display are shown.
During actual operation, only the
relevant items will be displayed.
Identifies the current operation
Shows the operating mode, etc.
* Multi language display is sup-
ported.
"Centrally Controlled" indicator
Indicates that operation of the re-
mote controller has been prohibited
by a master controller.
"Timer is Off" indicator
Indicates that the timer is off.
Temperature Setting
Shows the target temperature.

Operation Section

Set Temperature buttons
Down
Up
Timer Menu button
(Monitor/Set button)
Mode button (Return button)
Set Time buttons
Back
Ahead
Timer On/Off button
(Set Day button)
Opening the
cover
Note:
● "PLEASE WAIT" message
This message is displayed for approximately 3 minutes when power is supplied to the FTC unit or when the unit is recovering from a power fail-
ure.
● "NOT AVAILABLE" message
This message is displayed if a button is pressed to operate a function that the FTC unit does not have, or a function that is not available due to
the setting.
14
Day-of-Week
Shows the current day of the week.
Time/Timer Display
Shows the current time, unless the
simple or Auto Off timer is set.
If the simple or Auto Off timer is set,
shows the time remaining.
TIME SUN MON TUE WED THU FRI SAT
TIMER
AFTER
˚F˚C
TEMP.
ON/OFF indicator
Indicates if timer is set ON/OFF.
Hr ON
AFTER OFF
ERROR CODE
FUNCTION
˚F˚C
WEEKLY
ON/OFF
"Locked" indicator
Indicates that remote controller but-
tons have been locked.
Timer indicators
The indicator comes on if the corre-
sponding timer is set.
Error indicator
Comes on when error occurs.
Temperature indicator
Shows the current water tempera-
ture.
(Power On indicator)
Indicates that the power is on.
ON/OFF button
Setting change button
CIR. WATER button
(<Enter> button)
Not available
TEST run function is not
available with this FTC unit.
Self check (Clear) button