Yamaha BRX-610 Bedienungsanleitung Seite 35

■ Registering HDMI components to TV
1
Select this unit as the input source of the TV.
2
Select Disc/USB/Network as the input source of this
unit.
3
Check that the image from this unit is correctly
displayed on the TV.
4
Check that the HDMI control function works (turn on
this unit or adjust the volume level using the TV
remote control).
y
For some HDMI components, you only need to set the HDMI
control function. Registering HDMI components to TV is not
required in this case.
If the HDMI control function is not working
Check the following:
• The TV is connected to the HDMI terminal of this unit.
The HDMI control function is set to [On] in SETUP
menu (p. 35).
• The HDMI control function is enabled on the TV. (Also
check the relative settings such as power interlock
function or speaker priority.)
The HDMI control function is not working even
checking the above
• Turn off this unit and the TV, and then turn them back
on again.
• Unplug the AC power supply cable of this unit, the TV
and external components connected to the TV with
HDMI.
Plug them in again after about 30 seconds.
■ Changing the connection method and
connected components
When the connected components and jacks are changed,
reset this unit with following procedures.
1
Turn off the HDMI control function of the TV and
this unit, turn off all connected devices, and change
the connections.
2
Perform the step 1 to 3 of "Setting the HDMI control
function" (p. 30).
USING USEFUL FUNCTIONS
31
En