Installation Instructions; Instructions And Regulations; Installation - STIEBEL ELTRON SOM 7 PLUS Bedienung Und Installation

2. Installation instructions

2.1 Instructions and regulations

Carry out the installation in accordance with
current technical rules. Observe all accident
prevention regulations issued by professional
bodies and legislation. Incorrect use or
prohibited modifications during installation
result in the loss of all warranty rights.
Observe all applicable national and
regional regulations and instructions.

2.2 Installation

Only install this appliance in dry indoor
locations. To function correctly, ensure that
this appliance must not be exposed to strong
electromagnetic fields. Ensure that the
controller can be separated from the mains
supply by an additional isolator, which can
separate all poles with at least 3 mm contact
separation, or with an isolating facility in
accordance with current regulations. When
installing the power cable and the sensor
leads, ensure that they are routed separately.
1. Undo the Phillips screw from the fascia and
pull the panel downwards off the casing.
2. Mark the support point on the base and
pre-fit the rawl plug supplied with the
appropriate screw.
3. Hook the casing into the support point,
mark the fixing point on the base (hole
spacing 130 mm), then fit the lower rawl
plug.
4. Hook the casing in at the top and secure
with the lower fixing screw.
30
(for contractors)
1 Fascia
2 Pushbutton
3 Display
4 Fuse 4A (slow)
5 Cable glands with strain relief straps
Support
Fixing