BENE LEVEL LIFT PURE Bedienungsanleitung Seite 9

SAFETY INSTRUCTIONS
23. For the above reasons do not install the control unit:
above or below heat sources ( e.g. heaters), at places
exposed to direct sunlight, in small, unventilated or
humid rooms, near easily flammable materials or near
high-frequency devices (e. g. transmitters, radiation
equipment or similar).
Warning: If a fault occurs, then any attempt to oper-
ate the drive before the safety shutdown is activated
may result in the desktop moving slightly. Please
take care to avoid possible danger of crushing!
Warning: The collision protection is inactive during
all reset processes (section 5). Please take care to
avoid possible danger of crushing!
Please note: If the product is visibly damaged, it
must not be installed or used!
24. After 2 minutes of continuous operation the system
automatically shuts itself off and cannot be used
for an additional 18 minutes. This keeps the motor
from overheating.
25. Do not exceed maximum load of
75 kg/100 kg.
9