Tyre Pressure - Viking MF 860 Montageanleitung

EN
ENGLISH
seat. This plays an important role in the machine's
safety system.
On delivery, the switch is suspended from both its
cables in the seat bracket. To facilitate installation,
disconnect the switch from the cables.
Then install the switch on the underside of the seat
using the screws C (fig. 6).
Connect the switch to the cables again. The cables
can be connected to any pin. Install the seat as
shown below.
SEAT
Install the seat on the seat bracket (fig. 7).
In the rear holes, the screws H should be used
along with the shoulder washers G. Tighten the
screws.
Then place the knobs I with the washers J in the
front holes.
The seat can be moved backwards or forwards.
Place the seat in the desired position and then tight-
en the knobs properly.
The seat can be folded. If the machine is parked
outside when it is raining, fold the seat forwards to
protect the seat cushion from getting wet.
KNOB
In order to compensate for any axial play, the shim
washers E and/or F should be used.
First check whether and if so how many shim
washers are required.
Then install the knob by knocking in the tension
pin D (fig. 8).
DRAWING PLATE
Screw the drawing plate K into the two holes on
the underside of the bumper using screws L and
nuts M (fig. 9). Tighten the screws properly.

TYRE PRESSURE

Check the air pressure in the tyres. Correct air
pressure:
Front: 0.6 bar (9 psi), Rear: 0.4 bar (6 psi)
ACCESSORIES
For the installation of accessories, see separate in-
stallation guide supplied with each accessory.
7