Viking MF 860 Montageanleitung Seite 6

EN
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures under "ASSEM-
BLY" have been carried out.
ACCESSORIES BAG
The machine is supplied with a plastic bag contain-
ing components which must be installed prior to
use. The bag contains (fig. 1):
Pos. No. Designation
A 1 Sparking plug sleeve
B 1 Torsion pin ditto
C 2 Screw (MF 860)
D 1 Tension pin
E 1 Shim washer
F 1 Shim washer
G 2 Shoulder washer
H 2 Screw
I 2 Knob
J 2 Washer
K 1 Drawing plate
L 2 Screw
M 2 Nut
ENGINE CASING
To inspect and maintain the engine and battery, re-
move the engine casing. Dismantling:
1. Unscrew the fuel cap/fuel gauge.
2. Pull up the rubber strap at the front edge of the
casing (fig. 2).
3. Carefully lift off the engine casing (fig. 3).
Assembly:
1. Place the casing over the lip on each side.
2. Make sure that the pins on the rear edge of the
casing go down into the respective holes (fig. 4).
3. Secure the front edge of the casing with the rub-
ber strap (fig. 2).
4. Finally, screw in the fuel cap/fuel gauge.
6
ENGLISH
Dimension
6 x 36
16 x 38 x 0.5
16 x 38 x 1.0
8 x 20
8.4 x 22 x 1.5
8 x 20
M8
BATTERY
The battery is a valve-regulated battery with 12 V
nominal voltage. The battery is completely main-
tenance free. You don't have to check or top up the
electrolyte level.
On delivery, the battery is in the accessories box.
The battery must be fully charged be-
fore being used for the first time. The
battery should always be stored fully
charged. If the battery is stored while
totally flat it could sustain permanent
damage.
If the machine is not going to be used for an ex-
tended period (more than 1 month), the battery
should be charged, disconnected and then stored in
a cool, safe place. Charge the battery completely
before reinstalling.
The battery can be charged in two ways:
1. You can allow the engine to charge the battery.
In this case it is very important, above all when
starting the machine for the first time and when
it has not been used for a long time, to allow the
engine to run continuously for at least 45 min-
utes.
2. Via a battery charger. This must be a charger
with constant voltage. The battery can be dam-
aged if a standard type battery charger (for acid
batteries) is used.
Do not short circuit the battery's termi-
nals. Sparks occur which can result in
fire. Do not wear metal jewellery which
can come into contact with the battery
terminals.
In the event of damage to the battery
casing, cover, terminals or interference
to the strip covering the valves, the bat-
tery should be replaced.
Position the battery in the appropriate place under
the engine casing (fig. 5) and connect the battery
cables.
Note! To avoid damage to the engine and the bat-
tery, the positive battery cable (+) should always
be connected to the battery first.
Do not run the engine when the battery is discon-
nected.
SEAT SWITCH (MF 860)
A switch must be installed on the underside of the