Safety Instructions - IFM Electronic efector 110 GM701S Betriebsanleitung

Terms and abbreviations . . . . . . . . . . . . . . . . . . . . . . .Page 37
TÜVNord certificate . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 110
Type test certificate . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 111
EC Declaration of Conformity . . . . . . . . . . . . . . . . . . .Page 112
CULus certificate . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 113

1. Safety instructions

Follow the operating instructions.
Non-observance of the instructions, operation which is not in accordance
with use as prescribed below, wrong installation or handling can affect
operator and plant safety.
For mounting and prescribed use of the product the notes in the
operating instructions must be carefully observed and the applicable
technical standards relevant for the application have to be considered.
In case of non-observance of notes or standards, specially when
tampering with and/or modifying the product any liability is excluded.
The unit must be installed, connected and put into operation by a
qualified electrician trained in safety technology.
After set-up the system has to be subjected to a complete
function check.
Disconnect the unit externally before handling it. Also disconnect any
independently supplied relay load circuits.
For installation the requirements according to EN 60204
must be observed.
In case of malfunction of the unit please contact the manufacturer.
Tampering with the unit can seriously affect the safety of people and
the plant. This is not permitted and leads to an exclusion of liability and
warranty.
Suitability of the product for a certain application or under
special operating conditions cannot be assured and must
be ensured by the user.
UK
21