Eufab AMBER III Bedienungsanleitung Seite 11

Assembly:
Place the U-bracket on the U-bracket mount of the base frame. Secure the U-bracket with the supplied lock
screws (M8 x 60), washers and knob nuts M8. The knob nuts must be mounted on the inside (see
photograph).
Caution: You must tighten both knob nuts very firmly to ensure that the U-bracket is flush against the U-
bracket mount.
Step 3
Components
Mounting the frame holder
Undo the handle screw of the frame holder and rotate out fully. Open the cuff of
the frame holder and place the inserts around the U-bracket at a position
suitable for your bicycle. Place the cuff around the inserts and push firmly
together. Close the frame holder using the handle screw (but do not tighten).
Mounting the license plate holder
Remove the screws from the lamp mount before installing the license plate holder and then mount the
license plate holder. The license plate holder must be at the same height as the lights.
Clips
Inserting the license plate
The mounting clips for securing the license plate
are push-out parts in the holder. Break out two of
the clips. Slide the license plate into the holder,
then push the clips into the cut-outs to secure the
license plate.
Laying electrical cables
Cut-outs
Secure the cables of the lights to the underside of the rack using the supplied cable ties. Make sure that the
cables cannot be damaged when lowering and raising the rack.
Mounting the short tensioning straps
Insert the short tensioning strap from the inside to the outside below the bike
holder and then from the outside to the inside through the slots of the bike holder
(see photograph).
Attaching the plastic covers
Fit the plastic covers onto the middle of the wheel rails.