Silvercrest IAN 286383 Bedienungs- Und Sicherheitshinweise Seite 16

Use provided USB cable
charging cable purchased from reliable
supplier. Connect USB Type A port to
USB output
And then connect USB cable
other charging cable micro-USB port
to device to be charged. The charging
process will start automatically.
The display
status (in percentage) and the connected
output port.
In case if the charging process does not
begin immediately, press the Display /
LED button
ing process. The current battery status of
the power bank
the charging process by the display
Note: Usage of 5 V/1A or 5 V/2A out-
put shown on display are only informa-
tion regarding to the used of USB port
and not actual measured values.
To end the charging process, separate
the USB charging cable from the mobile
device and the power bank
charge / discharge status display
switch off after approx. 8 seconds.
16 GB/IE/NI
or of power bank
1 3
will show the charging
4
lightly to begin the charg-
5
is displayed during
6
or other
7
or
7
4
. The
6
will
4
.
6
9
.