Gryphon™ M Configuration - Datalogic GRYPHON M-Serie Kurzanleitung

UK/US
When the above procedure is no longer effective, the batteries must be
changed. To change the batteries of your reader, unscrew the battery cover
screw, replace the old batteries with new ones, then insert the cover in the
handle and screw it back into place. (See the following figures).
Dispose of the batteries as required by the relevant laws in force.
GRYPHON™ M CONFIGURATION
When the cradle is connected and powered, configure the Gryphon™ M by
reading the following codes in the given sequence and follow the instructions.
Note: for the numeric code selection of step 3, use the table at the end of this
Quick Reference.
1.
2.
3.
All readers used in the same area must have different addresses.
4
CAUTION
Restore Gryphon™ M default
Enter configuration
Set Radio Address
four digits for the Gryphon™ M Address
(from 0000 to 1999).
+
+
DATALOGIC