Intended Use; Operation - AL-KO Comfort series Bedienungsanleitung

In the event of damages, proceed as follows:
1. Disconnect the connection line from the
power supply immediately.
Electrical requirements:
−
230 V/50 Hz AC
−
Minimum section
connection line = 1,5 mm²
−
Minimum fuse protection power supply
connection = 10 A
−
Residual current circuit breaker
Maximum release current = 30 mA.
Danger!
Never use the appliance with power
plugs without residual current circuit
breaker.
Symbols
On the appliance
Read
instructions

operation!

Keep other people out of the
danger zone!
Pull
working on the cutting unit!
Attention: Danger! Keep the
connection line away from the
cutting equipment.
Attention:
hands and feed away from the
cutting equipment. In case of
a damaged connection line
pull out the plug immediately.
In these operating instructions
Danger!
Damage to people threatens if not
complied with.
Attention!
Damage to property threatens if not
complied with.
Note:
Information
application suggestions.
Translation of original user instructions
the operating
before starting
the plug out before
Danger! Keep
on the product

Intended use

Proper use
This appliance
scarifying/aerating (loosening and aerating of the
lawn).
It is only suitable for private use in home and
hobby gardens.
Improper use
The appliance must not be used in permanent
operation and not in industrial environments.
Operating times for electric scarifiers
The operating times for scarifiers depend on the
respectively applicable regulations of a country.
Local provisions can define different operating
times.
Unpacking/Mounting
Danger!
Only put the appliance into operation
after assembly of all parts has been
completed.
1. Remove the appliance from the packaging.
2. Check the content for completeness. In the
event of deficiencies inform your dealer.
3. Execute the assembly of the components
according to the assembly plan on page 2.
Operation
Commissioning
Adjusting the working depth (picture A)
Danger!
Only with the motor switched off and the
roller at a standstill.
1. Press the handle to lift the front axle and to
discharge the front wheels.
2. Push the turning knob down (picture A) and
turn to level "2".
Danger!
Operate the appliance only, when no
parts (e.g. rear flap) are missing or
defective and when the connection line
and
is free of damages.
is only intended for
GB 2