General Description; Power Supply - GYS START 200 Betriebsanleitung

Translation of the original instructions
• Service should be performed by a qualified person.
• Warning! Always remove the power plug from the wall socket
• Regularly take off the cover and remove dust with an air gun. Take
• Under no circumstances should solvents or other aggressive
• Clean the device's surfaces with a soft, dry cloth.
Regulations
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling

GENERAL DESCRIPTION

The START range is designed to charge and start lead-acid batteries, 12V (6 elements) and 24V (12 elements) :

POWER SUPPLY

Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The device must be positioned so that the socket is always accessible.
The machine must be connected to a single phase socket (230 V) WITH earth protected by a 16A circuit breaker.
CONNECTION AND DISCONNECTION
IMPORTANT ! Before any connection to a vehicle battery, make sure that the booster isn't connected to the mains and
that the booster's switch is set to OFF. Also, check the battery polarity.
Warning : the cables must not be kinked or in contact with hot or sharp surfaces.
• Disconnect any electronic system from the battery during the charge (do not charge the battery when it's connectd
to the vehicle).
10
START 200-300
before carrying out any work on the device.
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
cleaning agents be used.
facility. Do not dispose of in domestic waste.
Start 200
Start 300
Charging capacity
53 - 240 Ah
38 - 300 Ah
Starting capacity
35 - 80 Ah
35 - 100 Ah
EN