General Description - GYS STARTPACK 12.24 Übersetzung Der Originalbetriebsanleitung

Translation of the original instructions
Thank you for your choosing STARTPACK – this is a high quality product and in order to get the maximum from it, we
advise you to carefully read this instruction manual. Please also retain the manual for future reference.

GENERAL DESCRIPTION

This stand-alone starter is aimed to start vehicles equipped with a 12V or 24V lead batteries (liquid or gel electrolyte)
from small cars to bigger trucks.
STARTPACK contains 2 high performance 12V batteries. For it to work properly and to ensure the durability of internal
batteries, it is necessary to connect the STARTPACK to the mains, and to turn the product on 12V position to be charged
after each use.
USING AS A STARTER
• Unplug the socket from the mains.
• Turn the battery-switch on OFF.
• Plug the red clamp to the (+) and the black clamp to the (-).
NB: In the event of polarity inversion, Startpack 12-24 will sound a buzzer and a show a red led
warning.
• Switch the selector on 12V or 24V depending on the battery of the vehicle you wish to start.
• Turn the key of your vehicle in order to activate the start function
NB : if the vehicle does not start, wait 3 minutes between attempts to start
A vehicle which does not start after the third attempt probably has a problem unrelated to the bat-
tery: alternator, spark plug,...
• Once the vehicle has started, turn the battery switch on OFF.
After a start or a high consumption of batteries, the red light will flash to warn you that internal
batteries should be recharged.
• Unplug the black clamp then the red clamp from the vehicle.
To preserve the life of internal batteries, be sure to recharge the product (see next paragraph) after
each use.
USAGE AS A CHARGER (RECHARGE OF INTERNAL BATTERIES)
In order to have your Startpack fully operational and to ensure maximum output power, it is advised to charge it after
each use, and leave it charging until its' next use.
Startpack includes a high quality automatic charger, which will recharge its 2 batteries to a 100% charge, monitoring is
not necessary and a maximum charge will be maintained due to the advanced charging cycle (Floating System).
• After every use, près utilisation, turn the battery switch on OFF and disconnect the clamps from
the vehicle.
• Connect the charger to a 230V 50/60Hz socket.
• Switch the button on 12V mode
- Orange light: charging – voltage increasing
- Flashing Orange light: voltage regulation (2h to 16h if batteries are sulphated or deeply
discharged)
6
STARTPACK 12.24
WARNING : If you do not plug the 12V socket, the charge process won't start
The product will show you the charge status :
EN